WALLUKS DECORATIVE & INSULATION SILKY PLASTER-11915
Product Code: 001
WALLUKS Decorative & Insulation Silky Plaster (Liquid wallpaper) is made only from environmentally friendly and healthy raw components. Its components include textile, acrylic, polypropylene yarns, foam. This substance is not classified as dangerous according to Regulation 1272/2008/EC, 67/548/EC and Turkish local regulations. Has certificates and reports on the experiments carried out by the Turkish Institute of Standardization, as well as security and compliance certificates by the European Institute of Standardization. It hides minor surface defects and cracks, unlike traditional wallpaper, no peel off and no joints, create seamless coverage, rough walls conceal defects, cracks on the walls, no smell, do not fade in the sun, provide additional heat and sound insulation. Walluks very easily applied over the plaster allows you to 60-70 % reduction in time and repair costs. Decorative liquid wallpaper WALLUKS can be applied to any surface, columns, walls, ceilings, arches.
HOW TO USE:
Before the application repair the wall, remove the negative effects of the previously applied paint and defected areas. You can prepare the product with hand or mixer. Pour one bag of product into a tub or bucket with appropriate size. Add 10 litres water and mix for 6 to 8 minutes, then allow to rest. After resting for 30 minutes, the product is ready for use. Application thickness must be 2,5 to 3,5 mm. A bag of product will be sufficient to coat 4,5 m2 area with 3 mm average thickness. After the application, ventilate the area by keeping the windows open. Drying time 2 days. And then enjoy your life with different colours of WALLUKS.
1 stage: Put 10 liters water in to the bucket
2 stage: Add one packet of WALLUKS SILKY plaster in to the bucket
3 stage: Mix for 6 to 8 minutes with mixer
4 stage: Allow to rest for 30 minutes and then apply the wall with Plaster Trowel
5 stage: A bag of product will be coat 4,5 m2 -5 m2 area with 2-3 mm average thickness
6 stage: Drying time 1 days or 24 hours
IMPORTANT NOTICE
1.Adding too much water may cause formation of uneven surface and pattern Deformations after the application. Adding less water may cause a hard mixture and dry materials within.
2. Water must be between +10 and +30°C. Especially in winter, water temperature must not be lower than +15°C.
3. WALLUKS products cannot be applied under +5°C.
4. WALLUKS products cannot be applied onto smooth surfaces with non-water permeability feature such as glass, ceramic and plastic; and onto materials like wood and chipboard.
5. WALLUKS products cannot be applied on highly alkaline surfaces;