Aragonit EPS & XPS Board Adhesive-825

Product Code: A3010

Product Description: Cement-based polymer modified and added chemicals and high-strength adhesive is used for bonding of movement-resistant Thermal Insulation Board.
Uses: used in all kinds applied to interior and exterior bonding of thermal insulation boards.
Preparation: Application of surface roughness to be made, water absorption, stability is checked beforehand. Locations surface voids and repairs to be performed repairs done previously. The surface plaster dust, dirt, debris is cleaned from factors such as oil.
Mixing and Application: 6 - 7 liters. Clean water is discharged into the dust portion on the container and slowly added to the mixture and mixed until it becomes a homogeneous consistency. Low speed mixer is used to mix. To mix at a high speed prevents a homogeneous consistency. Wait 5 minutes after the maturation time is ready for use again stirred slurry. The prepared mixture is in the infinitive of the surfaces to be bonded plates / paste according to that applied in two ways. The surface is smooth and extending the gauge on the back of the plate is made complete carding fees. Coating the surface curvature is made to the 4 sides of the plate with mortar that is applied if the clustering method is applied on the surface of the gauge and the middle portion of the third block. Depending on weather conditions, the bonding process can move on to at least 24-36 hours after the plaster application. At least 40-45% of the adhesive to the back plate with the application of thermal insulation boards should be made. After coming into contact with the wall of the heat insulating plate plate provided in an effort to better bonding mortar and gently shifting smoothness is achieved with the miter gauge hitting. Plates must be laid staggered starting from the bottom surface. Flush plates come in all corners of the building using half and full plates is avoided. The plate thickness is used, the surface is smooth / is the case, it is important dowel selection according to the application method. Including the corners of the plate joints out 4 pieces per plate and 2 6 dowels are used. Application height and number of anchors is increased by the condition of the building facade.
Application tools should be washed with water after application. Applications can not be made while bonding material on the history and the surface must be cleaned. Hardened and used material in the vessel has completed the outlet.